Monsoon Multimedia Vulkano User's Guide download pdf (Page 56)

User Guide

SETUP THE STB CONTROL

Vulkano uses the same technology found in a universal remote control to send control codes for

a wide variety of STBs. The invisible light signal is sent from the small dark window at the front

left of your Vulkano (when looking at it from the front). This signal is strong enough, in many

cases, to bounce off the walls of your room and back into your STB’s remote control detector

window (which is often behind a dark piece of plastic on the front panel).

However, sometimes there may be a problem with the light getting from your Vulkano to your

STB. If you have no luck at all in getting your STB to respond, you should use the IR Blaster cable

which came with your Vulkano kit. Insert the plug into the hole label IR Blaster, located on your

Vulkano's rear panel. The location of the IR Blaster jack depends on the model of your Vulkano

device.

1 2 ... 51 52 53 54 55 56 57 58 59

No comments

Monsoon Multimedia Vulkano User's Guide Page 56